Mega System Tech iCV-01a Uživatelský manuál Strana 89

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 118
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 88
iCAMView Utility
Choose this if you want your Router to assign an IP address to iCAMView. This
is the default setting.
Obtain an IP address by Bootp
Choose this if you want to allow iCAMView to obtain an IP address using Bootp
protocol.
Use the following IP Address
Choose this if you want to assign a fix IP address, Subnet Mask and Gateway for
iCAMView.
1.2.3.2 Advanced (for password and HTTP configuration)
This section sets security password against unauthorised access to devices through
this Utility.
Fig.3 IP Configuration: Advanced settings
i. Device Password (when accessing from Utility)
Use this to set an access password to iCAMView Utility. Once set, the IP
Address will not be shown on the right display panel (see below).
Device Password can only be set for iCAMView from within the same LAN by
an Administrator.
11
Zobrazit stránku 88
1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 117 118

Komentáře k této Příručce

Žádné komentáře